4
PARTS and CONTENTS
HARDWARE CONTENTS (shown actual size)
Reflector X1
Side Panel x3
Front Panel x1
Bottom Plate x1
Support x4
Protective Guard x4
Glass Tube x1
Control Box Assembly x1
Damper x1
Mesh x1
17
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
CORRECTIVE ACTION
Pilot won’t
light
Note: Heater
operates
at reduced
efficiency
below 40ºF
(5ºC)
Cylinder valve is closed
Open valve
Blockage in orifice or pilot tube
Clean or replace orifice or
pilot tube
Air in gas line
Open gas line and bleed it
(pressing control knob in) for
not
more than 1-2 minutes or
until
you smell gas
Low gas pressure with cylinder
valve fully open
Turn cylinder valve OFF and
replace
cylinder
Igniter fails
Use match to light pilot; ob-
tain new
igniter and replace
Pilot won’t
stay lit
Dirt built up around pilot
Clean dirt from around pilot
Connection between gas valve and
pilot
assembly is loose
Tighten connection and per-
form
leak check
Thermocouple is not operating cor-
rectly
Replace thermocouple
Burner
won’t light
Propane cylinder is frosted over
Wait until the propane cylin-
der
heats and defrosts
Blockage in orifice
Clear blockage
Control knob is not in ON position
Turn control knob to ON
Burner
flame is low
Gas pressure is low
Turn cylinder valve OFF and
replace
cylinder
Outdoor temperature is less than
40º F and
tank is less than 1/4 full
Use a full cylinder
Control knob fully ON
Check burner and orifices for
blockage
Carbon
build-up
Thick black
smoke
Dirt or film on reflector and burner
screen
Clean reflector and burner
screen
Blockage in burner
Remove blockage and clean
burner
inside and outside
