5. Installation & Operation Guide
1. Description
This heater is equipped with our built-in
thermostat receiver - Receiver01 - on the
backside of the panel. Before starting the
installation, we recommend you to pair the
receiver to our remote control as a first step.
Follow the guide below to finish the pairing
to the Smart control system (e.g. Smart 1.0,
Smart 1.0Pro).
On the right see the drawing of the signal
lights and button of Receiver01.
1)
2)
3)
4)
Pair status signal light (
green light
)
Heating status signal light (
red light
)
“P” button
Power switch
2.Pairing to Sundirect Smart control
system
Step1: Plug your heater to an electrical outlet, switch the Power switch of Receiver01 on,
double press the “P” button and the
“Pair signal light”
will start to flash and is ready for pairing.
Step2: Power-off the remote control Smart 1.0/Smart 1.0Pro, long press the “SET” button. The “PAIR”
signal will show on the screen of the remote control. Wait until the
“Pair signal light” stops flashing
and glows green to finish the pairing.
Now the pairing process is finished and the Receiver01 will
only be commanded by Smart 1.0/Smart 1.0Pro.
Note: After the pairing process and once Receiver01 and Smart 1.0/Smart 1.0Pro are paired, the
pair signal light will always be on and the Receiver01 will be only commanded by the Smart 1.0/
Smart 1.0Pro. One Receiver01 can only pair to one Smart1.0/Smart1.0 Pro, however, One Smart 1.0/
Smart 1.0Pro thermostat can be paired to several Receiver01 if they are in the same room.
3. Bypass mode
Long-press the “P” button on Receiver01 until the
“Pair signal light” is off and the “Heating status
signal light “on,
the panel will be reset to bypass mode. In the bypass mode, the Receiver01 is
disabled and the panel is connected directly to the electricity.
7
