Sundance Spas 850Export Series, Инструкция по установке и эксплуатации

Страница: 37 / 49

NOTE: Do not apply varnish, shellac or other surface sealants to the
wood. These tend to react with the chemicals in the wood and the UV
rays of the sun, causing yellowing, flaking and peeling.
11.6 Intelli-Jet Cleaning Procedure
If you experience a sticky rotational jet, perform the following cleaning pro-
cedure. In most of these cases debris is present in the jet bearings and
must be cleared to achieve proper operation.
Note: This procedure is con-
sidered normal maintenance for this type of jet.
Procedure
1. Remove jet internal from
hot tub wall fitting by
placing your hand
around the outer jet
adjustment ring and
rotating it counterclock-
wise (fig. 1). Rotate jet
adjustment ring until it
stops at position (A).
Use additional force at
position (A) to continue
rotation until you feel a
“click” at position (B);
then feel the internal
release at position (C).
It may seem like your
are overtorquing the jet
internal between posi-
tions (A-B), however, additional force is necessary at position (A) to
unlatch its retaining mechanism from the wall fitting.
2. Fill a clean bucket with tap water and immerse jet internal. Rotate
submersed jet internal’s nozzle in a circular motion while moving it back
and forth allowing water to flow through both ends of the jet. This
motion allows slow moving water to wash back through the jet bearing
and dislodge any debris that might be lodged in the bearing. Clean each
jet internal for approximately 1 to 2 minutes twice a year, or when a
particular jets rotation appears sluggish, jerky, or obstructed.
Page 30
ENGLISH