Sundance Spas 850Export Series, Инструкция по установке и эксплуатации

Страница: 31 / 49

Page 24
plumbing. After 1 minute they both go off and Pump #1 runs for 1
minute. If the filter cycle is also set at 12:00 PM (noon), pump #1 will con-
tinue to run for the duration of the filter cycle.
10.0 Programming Instructions
10.1 Adjusting Time of Day
The Sentry control system remembers the time of day even in the event of a
prolonged power outage. However, it may occasionally be necessary to reset
the time of day. For example: if you are not in the Pacific Time Zone you
will want to reset the time for your own time zone. (The system will auto-
matically adjust to and from daylight savings time.) To accomplish this,
press
DISPLAY, MODE and DISPLAY within five seconds each. A number
representing the hour will be displayed, followed by AM or PM . The hour
will advance or decrease each time UP or DOWN is pressed within five
seconds. Then, press DISPLAY again to display the minutes. Adjust the
minutes as necessary by pressing UP or DOWN . After 5 seconds, the dis-
play will return to normal.
10.2 Changing Filter Cycle
The Sentry Control System allows you to easily adjust two separate aspects
of the filtration cycle (1) the time of day at which the cycle begins, (2) the
duration of the cycle. To make adjustments, first press
CYCLE to enter the
filter cycle programming mode. The LCD screen will display the following in
the upper right corner:
ADJUST START TIME
FILTER
CYCLE
This means the system is ready to accept your changes to the start time for
the filter cycle. Simultaneously, the large four-digit display in the center of the
screen displays the currently programmed start time for the cycle. At this
point, you have four options. You may:
(1) Press UP or DOWN to adjust the start time in increments of 15 minutes.
(2) Press SELECT to move down the menu from Start Time to Duration.
Press UP or DOWN to adjust the duration.
START TIME
ENGLISH