4
How it Works:
The Sunbeam® Advanced Remote Trainer should be used as a training aid for
you and your pet. This specially designed system will shut off if there is an
excess of corrections, for example, if there is continuous pressing. This is called
Over Correction Mode and will cause the unit to turn off and automatically
reset.
IMPORTANT:
The Sunbeam® Advanced Remote Trainer has a range of up to
150 yards. For the best results at long ranges, hold the remote above your
head and point to the receiver. Other factors that may affect range include
weather, terrain and other radio frequencies transmitted in the area.
OPERATING INSTRUCTIONS
Collar Battery Installation:
IMPORTANT:
This step is to be completed
when the collar is NOT on your dog.
• Remove two screws securing the battery
compartment using a cross head or flat head
screwdriver. (
fig. 1)
• Lift battery compartment from main body of
collar. (
fig. 2)
• Insert two CR2032 Lithium coin batteries into
battery compartment. Batteries should be
placed with the positive side facing down.
IMPORTANT:
Follow orientation as
described on graphics illustrated on battery
compartment. (
fig. 3)
• Replace battery compartment with two CR2032
Lithium coin batteries back into main body.
Note:
The battery compartment can only be
assembled in one orientation, do not force closed.
• Tighten the two screws using the cross head
screwdriver, do not over tighten.
• To turn on the unit press and hold the main
control button for 4 seconds. The unit will
beep twice and flash twice leaving one LED
illuminated to indicate which correction level is in use. To choose the right
correction level, refer to the READY TO USE section of this manual.
• To turn off the unit, press and hold the main control button for 4 seconds.
You will hear the unit beep once and then beep twice and flash twice
leaving no LEDs illuminated indicating the unit is off.
figure 1
figure 2
figure 3