strona: 12 / 14
In an unroll position, the front profile
(E)
and the intermediate support
(EX)
are adjacent to each other. When
roll up intermediate support slide down under gravity into the middle of the depth, where is lock
(Z)
(Fig No.8)
which stops the awning. When roll up the front profile
(E)
takes intermediate support and pushes him into a
position as shown in the figure above.
The crank drive - without gas spring.
The above version contains no gas spring. Front profil
(E)
with the fabric slides together on the side trolley
(O)
to the end of the side profiles
(X)
by the force of gravity down. (You can also attach an additional auxiliary
rope to the center of the profile - an additional order).
In order to stretch the fabric, trolleys
(O)
should be locked by the lock
(ZX)
(Fig. 9).
To be able to move the trolley, the lock
(ZX)
should be removed.
Put together several awnings.
Awnings, which are mounted side by side, can be equipped with a connecting parts and drainage. In this way
homogeneous roofing is achieved, which can protect against sunlight and rain (using a right angle of
inclination).
The above accessories must be ordered separately.
In this case, awnings are mounted side by side on the wall mount. In this way, creates a distance of 25 cm
between the side profiles. This space is protected by fabric. These fabrics have sewn PVC cord, which
allows to insert into the channels of the side profiles. (Plug should be removed from the side profile).
It is recommended that side profiles of the awning should be connect to each other by spacers to protect
against wind gusts.
