This product contains delicate electronic components. This means that if it is placed near an object that transmits
radio signals, it could cause interference. This could be, for example, mobile telephones, walkie talkies, CB radios,
remote controls and microwaves. If interference occurs, move such objects away from the appliance.
Sun System
®
1000 Watt DE Boss
®
Commercial Fixture:
Compliant with FCC Part 18 Class A (governs commercial use) and FCC Part 18 Class B (governs residential
use) as tested by an independent US testing lab in a true as used configuration. In our case, Northwest EMC
or ElectroMagnetic Investigations, Hillsboro OR.
This installation guide does not supersede national, state, or local regulations for electrical installations.
TROUBLESHOOTING… IF YOUR FIXTURE DOES NOT WORK:
1. CHECK YOUR ELECTRICAL SOURCE: Make sure the unit is plugged in properly and that the
breaker is not tripped or fuse blown.
2. CHECK THE LAMP COLOR: Make sure the lamp is fully seated in the socket.
POSSIBLE CAUSES CORRECTIVE MAINTENANCE
LAMP LOOSE
IN SOCKETS
Make sure that the lamp is fully inserted into the socket and that the
socket is in the closed position.
INCORRECT
VOLTAGE
Make sure you are using the correct input voltage with fixture. If
using incorrect voltage, disconnect the fixture from the power source
immediately.
DEFECTIVE OR
IMPROPER WIRING
Examine wiring to ensure it agrees with wiring diagrams on fixture label.
Check connections to see that they are secure. If wiring a 240 volt fixture,
DO NOT use a neutral. The correct wiring is two hot wires and a ground.
POOR ELECTRICAL
CONNECTIONS
Check wiring and lamp contact with socket. Make sure the lamp cord is
firmly seated in output receptacle.
INCORRECT
LAMP
Verify that you are using a 1000 Watt double-ended lamp.
LAMP
DAMAGE
Investigate possibility of outer bulb damage.
Look for broken tubes or loose metal parts. Replace lamp.
TROUBLESHOOTING GUIDE
Follow the troubleshooting tips below. If troubleshooting techniques fail, bring ballast back to
your place of purchase to request warranty service.
FCC compliance
This device complies with Part 18 of the FCC Rules.
Advisory statement
This product may cause interference to radio equipment
and should not be installed near maritime safety
communications equipment or other critical navigation
or communication equipment operating between
0.45-30 MHz.
The interference potential
of the device or system
The interference potential of the device or system is the
operating frequency; 110 kHz.
Maintenance of the system
Unplug the unit, wait 30 seconds, and plug the unit
back in.
Simple measures that can be taken
by the user to correct interference
Move the unit away from any radio device.
