Chapter 3
Installing the Sun XVR-500 Graphics Accelerator Hardware
21
FIGURE 3-2
Installing Sun XVR-500 Graphics Accelerator in a Sun Blade 1000/2000
System
5. Holding the two upper corners of the graphics board, push the board straight
down into the connector until the board is fully seated.
6. Replace the Phillips screw securing the graphics board bracket tab to the system
chassis.
7. Replace the side access cover.
Configuring Multiple Frame Buffers
To run more than one frame buffer, you must modify your
/etc/dt/config/Xservers
file. The Sun XVR-500 graphics accelerator device is
identified as
ifb
x (for example,
ifb0
and
ifb1
for two Sun XVR-500 graphics
accelerator devices). To modify the file:
Screw
Sun XVR-500
Bracket tab
graphics accelerator
Содержание XVR-500
