Sun Microsystems Sun StorEdge T3, Инструкция по установке, эксплуатации и обслуживанию

Страница: 75 / 148

Chapter 2 Installation 2-37
Proceed to Section 2.12 “Connecting the Host System” on page 2-40 to continue the
installation.
2.10.2 Partner Group Configuration
To define and mount the default volumes of a partner group, you must first make
sure the volume on the master unit is mounted and then add a volume on the
alternate master as follows:
1. On the disk tray, type
vol stat
to check the status of the volume.
Only the volume on the master controller unit is displayed.
Where:
■
v0
is the name of the volume.
■
unmounted
is the status of the volume.
■
u1d1 - u1d9
are the disk drives in the volume.
■
0
is the status of the disk drives in the volume.
All the disk drives should show a status of
0
. Possible status messages are listed in
TABLE 2-1
.
■
If the
vol stat
output shows the volume as mounted, skip to Step 4.
■
If the
vol stat
output shows the volume as unmounted, go to the next step.
2. Type
vol mount
to mount the volume.
3. Type
vol stat
to verify that the volume on the master controller unit is
mounted.
t300:/:<1>vol stat
v0 u1d1 u1d2 u1d3 u1d4 u1d5 u1d6 u1d7 u1d8 u1d9
unmounted 0 0 0 0 0 0 0 0 0
t300:/:<2>vol mount v0
t300:/:<3> vol stat
v0 u1d1 u1d2 u1d3 u1d4 u1d5 u1d6 u1d7 u1d8 u1d9
mounted 0 0 0 0 0 0 0 0 0