Chapter 1: Maintaining and Upgrading the Hardware
2
Upgrading the Hardware—Sun Cobalt Control Station
Opening the Sun Cobalt Control
Station
1.
Power down the control station. See “Powering Down” in the PDF
Using the
LCD Console
.
2.
Unplug the control station from the power supply.
3.
Remove the power cord from the rear of the control station. The cable is
located beside the power switch. See Figure 1.
4.
Using a #2 Phillips screwdriver, unscrew the top cover of the control station.
Ten screws hold the top cover in place. The screws are labeled 1 through 10
in Figure 2.
Figure 1 shows the rear view of the Sun Cobalt Control Station. Figure 2 shows
how to remove the top cover of the Sun Cobalt Control Station.
Warning:
You must power down the Sun Cobalt Control Station
before opening the unit.
✍
Note:
If the Sun Cobalt Control Station is mounted in an equipment
rack, remove the control station from the rack and take it to a
service area. Do not attempt this upgrade while the Sun Cobalt
Control Station is still in the equipment rack.
