Sun Microsystems StorageTek T9840, Руководство пользователя

Страница: 83 / 110

Messages
95739 • Revision YA Chapter 5 Indicators and Messages 83
Online The tape drive is online. None
OnLn Pend The online state is pending completion of
IPL diagnostics. None
Power Fail
The power supply failed. Contact authorized service personnel.
Reading The tape drive is reading data. None
Ready A The loaded cartridge tape is a VolSafe
cartridge. None
Ready F
The loaded cartridge tape is write-
protected. None
Ready H A loaded high-density data cartridge is
write-enabled by the cartridge write-
protect switch in the unlocked position. Reload with low-density cartridge or
intentionally over-write from BOT.
Note: High-density data cannot be read by a
T9840A/B drive. T9840D data cannot be read by
a T9840C drive.
Ready L A loaded low-density data cartridge is
write-enabled by the cartridge write-
protect switch in the unlocked position. Use for read-only jobs or intentionally over-
write from BOT.
Note: Low-density data files can be read, but not
revised by a T9840C/D drive.
Ready U The loaded cartridge tape is write-
enabled (write-unprotected). None
Rewinding The tape drive is rewinding. None
Save Fails The new configuration cannot be saved
because the read-access memory (RAM)
may be defective. This message is associated with changing the
tape drive configuration, a task for authorized
service personnel only.
SavingDump A dump is being saved to non-volatile
memory. None
Start Init Initialization has started. None
Trapped
The IPL process is trapped in a loop. IPL the tape drive again. If the problem persists,
contact authorized service personnel.
Unloading A cartridge tape is unloading. None
UnWr xxxx ,
where
xxxx
is an
FSC
The Unload switch was pressed during a
write operation. Some data remains
unwritten. To write the unwritten data, issue the command:
ESCON Swap in the VM/MVS
environment
Or, Press the
Unload
switch again; the
unwritten data is lost.
Write Prot The tape drive attempted to write to a
write-protected cartridge tape. Change the switch on the data cartridge tape to
enable writing.
Writing The tape drive is writing data. None
TABLE 5-2
Operator Panel Display Messages (Continued)
Display Meaning Recommended Action