Sun Microsystems StorageTek T9840, Руководство пользователя

Страница: 68 / 110

Power-on the Drive
68 T9840 User’s Reference Manual • September 2008 Revision YA • 95739
Power-on the Drive
To apply power to the desktop or rack-mount configuration:
1. Make sure the power cord is connected from the receptacle on the chassis rear panel
to an AC power outlet or power strip.
2. Make sure that all interface cables are fully seated.
3. Set the power switch on the back of the drive or the rear panel to on (|).
The drive(s) will power-on and perform an initial program load (IPL).
■
The drive
power
indicator flashes.
■
Various messages relative to the IPL sequence appear in the operator panel display
window. These messages do not require any action from you.
When the drive successfully completes an IPL:
■
The drive
power
indicator is steady
■
An asterisk (*) appears in the operator panel display window
Power-off the Drive
To remove power from the desktop and rack-mount configuration:
1. Make sure the tape drive is not in use.
Check for the following elements:
a. There are no active jobs, applications, or programs using this drive.
b. The operator panel activity indicator is steady and not flashing.
c. The display window does not indicate any activity relative to tape movement,
such as reading, writing, or locating.
2. Make sure a data cartridge is not loaded in the tape drive (see “Unload a Data
Cartridge” on page 72 , as necessary).
3. Set the power switch on the rear panel to off (O).