Sun Microsystems Netra T2000, Руководство по обслуживанию

Страница: 91 / 138

Chapter 4 Replacing Cold Swappable FRUs 77
6. Carefully work the card out of the socket.
7. Place the card on an antistatic mat.
8. Rotate the hold-down bracket so that it does not protrude into the chassis.
▼
To Replace PCI Cards
Use this procedure to replace PCI-E and PCI-X cards.
1. Unpackage the replacement PCI-E or PCI-X card and place it on an antistatic mat.
2. Locate the proper socket for the card you are replacing.
3. Rotate the PCI hold-down bracket 90 degrees so you can install the card.
4. Insert the card into the socket.
5. Rotate the PCI hold-down bracket 90 degrees to lock the card in place.
6. Perform the procedures described in “Common Procedures for Finishing Up” on
page 103 .
▼ To Remove DIMMs
Caution – This procedure requires that you handle components that are sensitive to
static discharges that can cause the component to fail. To avoid this problem, ensure
that you follow antistatic practices as described in
“To Perform Electrostatic
Discharge (ESD) Prevention Measures” on page 72 .
1. Perform the procedures described in “Common Procedures for Parts
Replacement” on page 67 .
2. Locate the DIMM (
FIGURE 4-8
) that you want to replace.
Use
FIGURE 4-8
and
TABLE 4-1
to identify the DIMM you want to remove.
Note – For memory configuration information see “To Add DIMMs” on page 113 .