Sun Microsystems Netra T2000, Руководство по обслуживанию, Страница: 75 / 138

Chapter 3 Replacing Hot-Swappable and Hot-Pluggable FRUs 61
Hot-Swapping the Rear Blower
The rear blower on the Sun Fire T2000 server is hot-swappable.
The following LEDs are lit when a blower unit fault is detected:
■
Front and rear Service Required LEDs
■
LED on the blower is lit.
▼
To Remove the Rear Blower
1. Gain access to the rear of the server where the faulty blower unit is located.
2. Release cable management arm tab (
FIGURE 3-3
) and swing the cable management
arm out of the way so you can access the power supply.
3. Unscrew the two thumbscrews (
FIGURE 3-4
) that secure the rear blower to the
chassis.
FIGURE 3-4
Removing the Rear Blower
4. Grasp the thumbscrews and slowly slide the blower out of the chassis, keeping
the blower level as you remove it.
▼ To Replace the Rear Blower
1. Unpackage the replacement blower.
2. Slide the blower into the chassis until it locks into the power connector at the
front of the blower compartment (
FIGURE 3-5
).
LED