Sun Microsystems APOLLO OC48, Инструкция по установке и эксплуатации

Страница: 42 / 78

22 Sun OC48 Packet Over Sonet Adapter Installation and User’s Guide • December 2001
FIGURE 4-2
Detail Location of Keys for PCI Slots
4. Using a Phillips screwdriver, remove the PCI filler panel from the slot in which
you want to insert the PCI adapter.
Save the filler panel screw for (Step 7).
5. Holding the PCI adapter by the edges, align the adapter edge connector with the
PCI slot. Slide the adapter front panel into the small slot at the end of the PCI
opening.
6. Applying pressure at both corners of the adapter, push the PCI adapter until it is
firmly seated in the PCI slot.
Caution –
Do not use excessive force when installing the adapter into the PCI slot.
You may damage the adapter’s PCI connector. If the adapter does not seat properly
when you apply even pressure, remove the adapter and carefully reinstall it again.
7. Secure the adapter to the PCI slot using the screw you removed in Step 4.
8. Repeat Steps 1-7 to install the second Sun OC48 Packet Over Sonet adapter.
9. Detach the wrist strap. Follow the steps in the Administration Guide that came
with your system to complete installation of an I/O adapter and prepare to operate
the system.
After you install the cards, you will be ready to install the SRP clock and data cables.
Continue on to the next section to install these cables.
▼
To Install the SRP Clock and Data Cables
Immediately after you install the cards, then install the SRP clock and data cables
before you bring up the system.
1. Connect the SRP clock cables.
FIGURE 4-3
shows a detail view of the SRP clock cable posts, and a detail view of the
two crossed SRP clock cables attached to the Sun OC48 Packet Over Sonet adapters.
This example shows the adapters installed in a Sun Fire 6800 server.
■
Connect the SRP clock cables to the two Sun OC48 Packet Over Sonet adapters.
66 MHz
33 MHz