Sun Microsystems APOLLO OC48, Инструкция по установке и эксплуатации

Страница: 30 / 78

10 Sun OC48 Packet Over Sonet Adapter Installation and User’s Guide • December 2001
▼
To Verify the Installation
After you have installed the Sun OC48 Packet Over Sonet adapter, but before you
boot your system, perform the following tasks to verify the installation. Refer to the
Solaris Handbook for Sun Peripherals manual or your Solaris documentation for the
detailed instructions.
1. Follow the steps in the Administration Guide that came with your system to
power on the system.
2. When the banner appears, press the Stop-A key sequence to interrupt the boot
process and display the OpenBoot (
ok
) prompt.
3. List the network devices on your system.
Use the
show-devs
command to list the system devices. You should see the full
path name of the
network
devices, similar to the example below. In this example,
the
network@4
device is the Sun OC48 Packet Over Sonet adapter.
In the example above, the names of the Sun OC48 Packet Over Sonet devices are
shown in bold, for clarity.
Note – If you do not see the device listed, check that the adapter is properly seated
and, if necessary, reinstall the adapter.
Booting the System
After verifying the adapter installation, follow the steps in the Administration Guide
that came with your system to do a reconfiguration boot.
You are now ready to install the software packages from the Sun OC48 Packet Over
Sonet 1.0 CD.
ok show-devs
ok show-devs
...
/ssm@0,0/pci@18,600000/pci108e,a14@1,3
/ssm@0,0/pci@18,600000/pci108e,a13@1,2
/ssm@0,0/pci@18,600000/pci108e,a12@1,1
/ssm@0,0/pci@18,600000/pci108e,a11@1
...