13
HOW TO USE
This lamp is fully protected against dust and water splashes from all directions. It is intended for outdoor or
indoor use. IP65 standard.
INSTALLATION :
The battery of this lamp recharges by its solar panel, make sure to expose it well, so that there is not an obstacle that
disturbs the radiation.
1 - Fixing the projector :
To make it easier to install, we advise you to unscrew the projector of your fastening leg by removing the two side
screws.
Attach the attachment leg to your holder and then re-raise the
LOOMI NEO.
IMPORTANT TIP: Make sure to position the projector's connection socket to the ground
.
2 - Fixing the solar panel :
To make it easier to install, we recommend unscrewing the solar panel from its fastening leg by removing the two side
screws.
Consider the 5-metre cable length between your LOOMI NEO and the solar panel before attaching it.
Attach the attachment leg to your holder and then re-raise the solar panel on its fastening leg.
Charging by SOLAR ENERGY :
•
Choose a clear outdoor location in full sun so that the solar panel receives at least 8
hours of direct radiation per day. If the lamp is placed in the shade, the load can be
reduced and the duration of the lighting will be
shorter at night.
• Depending on the time of year, weather conditions and the location of the solar
module, it may take a few days to charge before you can use the lamp. Three to four
days of charging in full sun can be considered a good indicator. In winter, it is normal
for the lighting duration to be reduced (2 to 3 hours of operation).
