PG 5
PLATFORM
1.
Position the finished Seat Support and
Ladder Assembly as shown in
figure 6
.
Note:
The welded U bracket faces the tree when
fully assembled.
Slide the Seat Support down
onto the Ladder Assembly and line up the bolt
holes.
2.
Position the Platform Assembly as shown in
figure 7
.
3.
Slide the platform forward and line up the
bolt holes from
Step 1.
Secure with two
2 1/2”
bolts and lock nuts
(figure 8).
Leave these
bolts hand tight for now.
4.
Position one of the Platform Support bars
as shown in
figure 9.
The bar should run from
the inside of the Upright to the outside of the
Platform as shown.
5.
Secure at the upper and lower hole using
one
1 3/4” bolt and lock nut
. Leave these bolts
hand tight until both bars are attached.
6.
Repeat for the opposite side.
7.
Wrench tighten bolts from
Steps 3 and 5.
6
SEAT
SUPPORT
LADDER
ASSEMBLY
8
2 1/2” BOLTS, LOCK NUTS -
WRENCH TIGHTEN STEP 7
9
EXPANDED
METAL REMOVED
FOR CLARITY
PLATFORM
SUPPORT
(PN 82067.030)
1 3/4” BOLTS, LOCK NUTS -
WRENCH TIGHTEN STEP 7
7
PLATFORM
(PN 82067.100)
WELDED
U BRACKET
FACES TREE
TOP LADDER
SECTION
