Summit LWBC30, Руководство пользователя

Страница: 7 / 16

7
The appliance should always be plugged into its own individual electrical outlet which has a voltage
rating that matches the rating label on the appliance. This provides the best performance and also
prevents overloading house wiring circuits that could cause a fire hazard from overheating. Never
unplug the appliance by pulling on the power cord. Always grip the plug firmly and pull straight out
from the receptacle. Repair or replace immediately all power cords that have become frayed or
otherwise damaged. Do not use a cord that shows cracks or abrasion damage along its length or at
either end. When moving the appliance, be careful not to damage the power cord.
Extension Cord
Because of potential safety hazards under certain conditions, it is strongly recommended that you do
not use an extension cord with this appliance. However, if you must use an extension cord, it is
absolutely necessary that it be a UL/CUL-Listed, 3-wire grounding type appliance extension cord
having a grounding type plug and outlet and that the electrical rating of the cord be 110 volts.
Installing the Stainless Steel Handles
This appliance included two stainless steel handles that are not
required to operate the unit. To install each handle, follow the
instructions below
1. Remove the gasket from the side of the door on which you
will install the handle.
2. Remove the screws from the bag included with your unit.
Put the screws into the holes where the handle will be
installed.
3. Align the handle with the screws, and tighten the screws
using a screwdriver, until the handle is both flush and
secured tightly against the door. DO NOT over-tighten, as
this may cause damage to the door surface).
Installing the Casters (optional)
1. Remove everything from the cabinet and lay the unit on a
clean, dry, and padded surface
2. Install casters into the holes on the bottom of the unit as
shown and tighten with a wrench
3. The two casters equipped with locks should be installed
on the front of the unit
4. Once all four casters are attached, return the beer
dispenser to an upright position
5. Allow the unit to sit for 8-10 hours before plugging in to
allow the refrigerant to settle.