Summit ADFD2D24, Инструкция по эксплуатации

Страница: 10 / 36

10
Installing the Stainless Steel Handles
This appliance includes two stainless steel handles
that are not required to operate the appliance. To
install the handles, follow the instructions below:
1. Remove the door gasket.
2. Install the handle with the screws provided. DO
NOT over-tighten as this will cause damage to
the stainless steel door surface.
3. Replace the door gasket.
Full Overlay Panel Installation Instructions
This model is designed for a field-installed overlay
panel, which can cover the stainless steel to give
a built-in appearance. The overlay panel and
appropriate hardware are not included with the
appliance, and you must install the panel yourself.
Please follow the instructions below for installation:
1. Remove any items stored inside the
drawers and take the drawers out.
2. Peel off the gasket and remove the handle
by removing the two screws that attach the
handle to the door.
3. Drill the 8 holes shown by using a 9/50” drill
bit on the 4 sides of the drawer door front.
(Fig.2)
4. Cut the overlay panels with 3/4” thickness
to the following dimensions: 23.34” x
13.93” (WxH).
5. If reusing the handles that came with the
appliance, drill two holes with a diameter of
9/50” in the overlay panel.
6. If user-supplied handles will be used, attach
the handles to the overlay panels by using the
flat head screws and drive the screws flush
with the panels.
7. Attach the handle and overlay panel together
to the drawer face using 2 M4x45 screws and
through the 2 existing holes on the door face.
Then attach the overlay panel to the drawer
face using 8 M4x45 screws and through 8
existing holes inside the door groove. (Fig. 3)
8. Attach the overlay panel to the drawer face
through the existing holes inside the door
groove, using the 8 M4x45 screws.
9. Peel back the gaskets, then align the left and
right side channels with the tracks in the
cabinet.