SET UP & USE:
Initial Set Up:
To set up the system, you will need two adults. One adult should be in the
nursery with the Baby Unit (transmitter) while the other is in a different
room with the Parent Unit (receiver).
Note: The Parent Unit includes a rechargeable battery and it should be
fully charged before using the monitor in portable mode. Charge the
battery for 12-16 hours. When the unit is fully charged, the LED under the
On/Off switch will remain on until it is unplugged. After the initial 12-16
hour charge, only charge the battery when the battery is low to achieve
optimal battery life.
Step 1: Place the Baby Unit in the nursery near the cot, on a flat surface,
and ensure the cord is more than 1 metre from the cot and out of baby’s
reach. Plug the AC adapter into a standard electrical outlet.
Step 2: Press the power button on the front of Baby Unit for 4 seconds to turn the unit on.
Step 3: Place the Parent Unit in the room from which you want to monitor baby. Plug the AC adapter into a
standard electrical outlet.
Step 4: Press the power button the front of the Parent Unit for
4 seconds to turn it on.
Step 5: Have the adult in the baby’s room speak at different levels to adjust the volume to the desired setting. The
volume can be adjusted up or down using the Volume Control buttons on the side of the Parent Unit.
Baby Unit Set Up in Nursery:
Place the Baby Unit (transmitter) on a flat surface, such as a desk or shelf (Fig A). NEVER place the Baby Unit or cords
within 1 metre of the cot.
Synchronizing Baby and Parent Unit:
Note: This digital monitor set is synchronized with security codes for privacy reasons. However, there are instances
that the Baby and Parent unit will lose it’s code and may require you to synchronize it again.
Step 1: Connect the Baby unit to it’s power supply and make sure unit is powered OFF.
Step 2: Turn ON Parent unit.
Step 3: Press and keep holding the “VOL +” button and at the same time press the POWER button for about 4
seconds. A continuous audible BEEP and red flashing lights will occur. The Parent unit is now ready to be synchronized.
Step 4: Within 20 seconds, turn on the Baby unit. A single BEEP will emit from the Parent unit to signify successful
synchronization.
Battery Installation:
Note: this step is only needed if replacing battery.
1. Locate the battery compartment door on the back of Parent Unit
.
2. Slide battery door off
.
3. Remove battery
.
4. Insert new battery and replace battery door.
A
28916 Baby Wave Deluxe IB 8L Eng p3.pdf 1 18/09/2013 13:15