Sumitomo TYPE-66M12, Руководство по эксплуатации

Страница: 21 / 68

Plugging
Insert the power cord into the power supply
module completely. POWER LED lights up
green when the AC power is supplied.
Power cord
11
Battery operation
Insert the battery module (BU-66S/L) into the module bay in the same way as inserting
the power supply module. (See “AC operation” at page 10 regarding installation and
removal of the battery module.)
Before inserting the battery module, ensure that the battery is charged enough.
(See
“Battery level check” at page 12.)
[Reference]
The splice cycles ( protection) per fully charged battery module is
approximately
80 cycles
.(BU-66S)
approximately
160 cycles
.(BU-66L)
(Condition: Using an unused battery module, 1 splice cycle shall be completed in 90
seconds in room temperature, without using a heated jacket remover.)
If the power is turned on after the battery module is installed in the splicer, the screen
that selects power supply will be displayed. Select the power supply that you use.
Battery operation
Car battery operation (Refer to page 14.)
バッテリユニットリフレ
Battery
DC Adapter Cable
Select Power Supply
MOVE SELECT
BU-66S/BU-66L
PC-V66
Caution
Check the voltage of AC power before use. The splicer should be grounded to
earth.
If voltage or frequency beyond the range stated flows in the power supply
module, a safety and protective device to prevent danger is activated and the
power supply module will stop. In that case, a new power supply module
should be purchased. Please contact our maintenance service center.