7
CAUTION
●
Do not use the products for purposes other than those shown on the nameplate or in the
manufacturing specifications; otherwise, electric shock, personal injury, or damage to the equipment
may result.
●
Do not place flammable objects around the reducer; otherwise, fire may result.
●
Do not place any object around the educer that will hinder ventilation. Insufficient ventilation can cause
excessive heat build-up that may result in burns or fire.
●
Do not step on or hang from the reducer; otherwise personal injury or damage to the equipment may
result.
●
Do not touch the shaft end or inside keyways; otherwise personal injury may occur.
●
When the unit is used in food processing applications, install an oil pan to protect against oil
contamination that may occur during equipment breakdown or failure; otherwise, oil leakage may
damage the products.
4-1 Installation Location
Ambient temperature
-10 to 40
℃
Ambient humidity
Max. 85%
Atmosphere
No corrosive or volatile gases, no steam
Dust-free, well-ventilated area.
Installation location
Indoors (Dry area with minimal dust)
・
Special reducers are required for installation conditions not described in these guidelines.
・
Reducers made for outdoor, explosion-proof or other special conditions are designed to operate under
those conditions without any problem.
・
Install reducers where inpection, maintenance and repair operations can be performed easily.
・
Install reducers on a sufficiently rigid base.
4-2 Installation Angle
Install reducers on a level base. (Contact factory for installation on an inclined base)
When the unit is manufactured for inclined installation, do not install it at any angle other than the one specified.
4-3 Installation Method
・
Install reducers on a sufficiently rigid base and use installation bolts corresponding to JIS strength class 10.9 or its
equivalent.
・
Use dowel pin when vibration or impact is high.
・
Alignment for reducer with motor mounted on the base plate is done prior to shipment. However due to
misalignment occurs during transport or condition of concrete base, re-align when install.
・
The rust preventive oil is applied to input shaft, output shaft, key and installing surface. Remove by wash
oil before installing. Do not use special solvent or sand paper.
4. Installation
