Sullair 02250175-949 R01, Руководство пользователя, Страница: 60 / 74

1600C LP USER MANUAL SECTION 5
60
When grease is pumped into the zerk, it is channeled
to the inner bearing and then flows back to the outer
bearing and eventually back out of the grease cap
hole refer to
Figure 5-2 . The procedure is as follows:
1. Remove the rubber plug from the end of the
grease cap.
2. With a standard grease gun filled with a qual-
ity wheel bearing grease, place the gun onto
the grease zerk located in the end of the
spindle. Make sure the grease gun nozzle is
fully engaged on the fitting.
3. Pump grease into the zerk. The old, dis-
placed grease will flow back out of the cap
around the grease gun nozzle.
4. When new, clean grease is observed,
remove the grease gun, wipe off any excess,
and replace the rubber plug in the cap.
MAIN FLUID FILTER SERVICING
Refer to Figure 5-3 . The main fluid filters are located
schematically in the coolant line between the
receiver tank and the compressor unit. The main filter
elements are replaceable. For installation of the filter
elements, follow the procedure explained below:
1. The compressor MUST be shut off and sys-
tem pressure MUST be relieved.
2. Position a suitable container beneath the
elements to catch fluid drainage.
3. Remove elements using a suitable tool.
4. Rotate element counterclockwise to remove.
5. Remove element and discard. These ele-
ments are not cleanable.
Figure 5-2: Typical E-Z Lube Axle
1. Rubber Plug 5. Grease Fitting
2. Outer Bearing 6. Metal End Cap
3. Inner Bearing 7. Spring-loaded Double Lip Seal
4. Grease Flow