SUHNER LXE 3, Руководство по эксплуатации

Страница: 4 / 13

GB
Machine components
1 Spindle
2 Right angle gear head
3 Water connector
4 Screw
5 Wrench 2 mm
6 Safety lever throttle
7 Ring throttle
8 Exhaust Hose
9 Muffler
10 Air hose
11 Wrench 22 mm
12 Wrench 17 mm
Adaptor kit
13 Handle extension
14 Hexagon nut
15 Side handle
Technical Data LXE 3 DH
at 90 PSI Operating Pressure
without oil with oil
Power 550 600 Watt
Torque ~6,5 ~7 Nm
Air consumption 31,5 31,5 cfm
full load 0,9 0,9 m
3
/min
Air consumption 36,7 36,7 cfm
no load 1,05 1,05 m
3
/min
No load speed 2'500 3'000 rpm
Sound pressure level
according to CEN/TC 255 80 dB(A)
Vibration according to
ISO/DIS 8662-4
with test disc dia 100 x 25 <2,5m/s
2
Weight without hose 1,5 kg
Recommended air quality
accord. to ISO/DIS 8573-1 3/4/4
Air hose ID 9,5 mm/3/8"
Grinding/Cutting wheels 150 mm/6"
(refer to APT catalog)
Spindle thread M 14 or
5/8"-11
Recommended Accessories
16 Coupling with min ID 7 mm/ 9/32"
17 1/2" -Service Unit ( Capacity 5-8
Micron). with wet air include
Lubricator
Suitable Tools:
18 Elastic support plate with bayonet
fitting 21
19/20 Surface grinding wheels / Grinding
rings / Grinding cups / Diamond tools.
Additional Abrasives and Tools
can be found in the the SUHNER catalogs
Air supply requirements:
The ISO/DIS quality specifications require, that
air is free of solid particles larger than 5
micron, remaining water content to be max. 6
g/m
3
(pressure dew point +3 degree C) and
air may contain 5 mg/m
3
of oil. Therefore
please observe the following:
• Operating with dirty and unlubricated air
reduces tool life substantially.
Before installing extension hoses, blow them
clean and minimize , if at all necessary
coupling and keep them clean.
• Rust will occur, if air supply is not lubricated
and wet. A few drops of air tool oil from time to
time will prevent rust and stops bearings from
seizing.
• Conserve:
Put some drops of oil in the air inlet and briefly
blow through.
Safety Instructions:
• Do not exceed max. operating speed of tool
and clamping element.
• Observe accurate mounting of insert tools.
• Observe mounting instructions for Mounted
Stones!
• Run tool for a couple of seconds under no
load, replace vibrating insert tools at once,
protect mounted points from knocks and
grease.
• Secure work, use clamps or a vise to hold
work.