SUHNER ABRASIVE SHS 350, Техническая документация

Страница: 23 / 72

Remove the blade housing by drawing it towards.
Detach the blade from the blade housing. To connect
the blade, follow the above instructions in reverse order.
Tighten the screws with max. 1.5 Nm. After connecting,
press the grease cup button two to three times.
V
ery shArp BlAde
!
2.1.3 c
Onnecting
/
detAching the thumB rest
Dissolve the tension nut with a socket spanner and pull
them out.
Pull the handle and the ring off from the mount.
Replace the ring with the thumb rest. There are different
possible positions available. Push the handle in the de-
sired position on the carrier. Screw the tension nut with a
socket spanner and tighten them.
2.2 r
Ating dAtA
Blade Ø 35mm
Maximum speed 6000min
-1
Vibration ≤2.5m/s
2
Weight 262g
The specified vibration value was measured with a
standardised test procedure. It can be used to
compare products or to make an initial assess-
ment of the exposure.
Loosening up your arms and hands at regular intervals
prevents muscle tenseness from adversely affecting your
health.
2.3 O
perAting cOnditiOns
Temperature range during operation: -7 to +50°C
Relative air humidity: 95% at +10°C not condensed
3.
handlIng
/ o
PeratIon
3.1 w
Orking instructiOns
Focus on an ergonomic stance and movements when
working with the tool. You should always stretch out the
thumb of the hand holding the hand piece. When work-
ing in sweeps or one continuous pass, keep the surface
of the blade as flat as possible on the surface you are
working. For maximum working efficiency we recommend
keeping replacement blades ready at all times.
During operations the tool must be lubricated reg-
ularly from the grease cup!
For any further questions on efficient working,
please contact the area representative or the manufac-
turer.
PT
ES
IT
EN
FR
DE
NL
PL
CZ
FI
SE
CN
EN
23