SUHNER ABRASIVE LSB 20, Техническая документация

Страница: 17 / 36

CN
PL
CZ
FI
SE
NL
PT
ES
IT
EN
2.4 Operating conditions
Temperature range during operation: 0 to +40°C
Relative air humidity: 95% at +10°C not condensed
3. handling / Operation
3.1 Tools
Use only clean tools!
3.1.1 Changing/Fitting the tool
Hold spindle by wrench flats with open end wrench and
release/tighten down collet chuck with open end wrench.
Perform a trial run a minimum over a period of 30 seconds
without load.
3.2 Working instructions
On failure of the compressed air release the valve
lever! To achieve an optimum result, move grin-
ding tool uniformly back and forth with light pres-
sure. Excessive pressure lessens the working capability
of the machine, as well as the life of the grinding tool.
4. Service / Maintenance
4.1 Preventive maintenance
Without a tool clamped in check no-load
speed periodically and after each mainte-
nance. Even if the machine still operates
perfectly, the motor should be removed, cleaned and the
four slides checked for wear by a specialist after approx.
300 to 400 operating hours.
FR
DE
EN
17