Remove 2 screws from console bin.
PART NUMBER
SPN0000582
ISSUE
v1.0
DATE
01/14/08
SUBARU OF AMERICA
PAGE
8
7
Feed dock cable (C) through hole
and tilt console upright as shown
in slide 9.
C
1”
(25mm)
C
Using 14 mm (9/16”) drill bit and
drill stop set to ½” drill a hole in
console bin as shown.
Caution:
failure to use drill stop may result
in damage to vehicle.
9
Route dock cable towards front of vehicle as shown. Dock cable should be routed behind HVAC
controls and up to the radio opening.
11
Pry gently around edges to remove
trim panel. Note: Gear selector must
be in “N” with parking brake set,
ignition off and vehicle on level
ground. For manual transmission
vehicles, shift knob must be removed
by unscrewing in a counter
clockwise direction.
10
Route dock cable from bottom of console bin
along existing wire harnesses as shown (C).
3/5
