Page 4
2-2
Installation Information
WARMING DRAWER WWD30
INSTALLATION INFORMATION
The Wolf Warming Drawer is designed to be set into a built-in wall or cabinet installation.
This section of the manual covers some of the installation issues that a service technician may need to know when
servicing a Wolf warming drawer. If additional installation information is needed after reviewing this section of the
manual, please refer to the installation guide or contact Wolf Appliance Co., LLC Customer Service Department at
(800) 332-9513.
Electrical Requirements:
NOTE:
All National Electrical Code regulations must be followed. In addition, be aware of local codes and ordi-
nances when installing your service.
• Dedicated 110 to 120 Volts AC, 60Hz, 15 or 20 ampere fused electrical supply
• Separate electrical circuit serving only this appliance
• A properly grounded 3-prong receptacle
NOTE:
For outdoor applications, the unit must be be connected to a properly grounded GFCI circuit.
Line
Voltage
(Power)
Neutral
Ground
TO AVOID SHOCK HAZARD, THE INSTALLATION SITE MUST BE EQUIPPED WITH A PROPERLY GROUNDED
3-SLOT RECEPTACLE TO MATCH THE 3-PRONG (GROUNDED) POWER SUPPLY CORD PROVIDED ON THE
APPLIANCE.
TO AVOID SHOCK HAZARD, NEVER REMOVE THE GROUND PRONG FROM THE PLUG OF THE POWER
SUPPLY CORD.
Figure 2-1. Electrical Receptacle
NOTE:
This appliance must be installed in accordance with National Electrical Codes, as well as all state, munici-
pal and local codes. The correct voltage, frequency and amperage must be supplied to the appliance from a dedi-
cated, grounded circuit which is protected by a properly sized circuit breaker or time delay fuse. The proper voltage,
frequency, and amperage ratings are listed on the product rating plate.
