Page 15
3-10
Electronic Control Information
WARMING DRAWER WWD30
LED Back Lighting Change:
Mode Entry:
Enter backlight setting preference by pressing and holding both “TEMP” and “TIMER” up arrow keys for 5 seconds.
Current backlight setting will appear in display.
Operations:
Use “TIMER” up arrow key to select the various setting. Setting will be saved and recalled in the event of a power
loss. Three settings available are Continuous mode Off (off bclt ALL, Continuous mode On, and ALL disabled.
Default setting is Continuous Mode Off.
Continuous mode refers to the Sabbath mode where appliance is running continuously and backlight can be selected
to be off or on.
Continuous mode On
, refers to backlight on continuously at a reduced illumination level to conserve
`
LED life. Outside of Sabbath mode, backlight works as normal based on drawer state at full illumination.
NOTE:
Left side of display will show “On” continuously, and the right side of display will flash between “bclt” and
“Sab”.
Continuous mode Off
, refers to backlight continuously off only in Sabbath mode. Outside of Sabbath mode, back-
light works as normal based on drawer state at full illumination.
NOTE:
Left side of display will show “Off” continuously, and the right side of display will flash between “bclt” and
“Sab”.
Disabled mode
, refers to backlight is always off regardless of operating mode.
NOTE:
Left side of display will show “Off” continuously, and the right side of display will flash between “bclt” and
“ALL”.
Mode Exit:
Once back lighting has been set to desired state, press “Power On/Off” key and setting will be saved.
NOTE:
If after 30 seconds of no additional key presses, mode will exit with last known state saved as LCD back
lighting preference.
TIMER
PROOF
LOW
PRESETS
HIGH
MED
TEMP
POWER
ON/OFF
PROOF
TEMP
TEMP
TEMP
ON
TIMER
Figure 3-14. Press TEMP & TIMER up arrow keys to enter. Press TIMER up arrow key to change settings.
