Undercounter Installation
12
Hinge Adjustment
IMPORTANT NOTE:
The undercounter unit should be
properly leveled before door hinge adjustments are made.
The top and bottom cabinet hinges are held in place with
three permanent adjustment screws. If the door needs
adjustment, loosen the adjustment screws and reposition
the door. Once in position, tighten the adjustment screws.
Refer to the illustrations below.
TOP DOOR
HINGE
ADJUSTMENT
SCREWS
Top hinge adjustment.
Bottom hinge adjustment.
ADJUSTMENT
SCREWS
BOTTOM
DOOR HINGE
Overlay Panel Installation
IMPORTANT NOTE:
For model UC-24BG, install screws in
all the mounting holes in the door frame. The nature of the
door panel with a narrow outer rim and no connecting
center member requires the support provided by the glass
door.
After the door panel installation is complete, apply the
cover patches or plugs provided over the holes on the
inside surface of the door.
The cover patches or plugs are part of the insulation
system on the door of the undercounter unit. Be sure to
cover all the holes in the door that were used.
The model UC-24BG glass door is made with a sealed,
double-wall tempered glass core. The drill must not
contact this core when drilling. Be sure the hole is
centered on the small groove in the front of the door
frame and the drill passes squarely through the frame.
If you are inexperienced with drilling, fasten the handle
from the rear of the door panel only.