10
T I M E R
O P E R A T I O N
The control panel of the steamer module has
an independent 99-minute timer. Refer to the
illustration below. This function can be used
with or without the unit in operation. However,
the steamer must not be in Lock mode.
To start the timer, touch the ”+” or ”–”
symbol until the correct amount of time is
shown in the timer display. The timer will
begin its countdown after a 2 second delay.
A warning beep will sound when the timer
has 1 minute left and begins to countdown
in seconds starting at 59.
A signal will beep when time has expired
and will continue to beep every 30 seconds.
Touch CLEAR to reset the timer.
W O L F
S T E A M E R M O D U L E
U S E & C A R E
Timer controls
Timer
display
A U TO M AT I C D R A I N
O P E R A T I O N
IMPORTANT NOTE: The steamer module
must be installed with a drain connection and
access to the drain through the base cabinet.
The DRAIN touch pad operation is functional
only while the unit is in Idle mode. The unit
must be unlocked and not in operation. Refer
to the illustration below.
To activate the drain:
1)
Touch DRAIN for 3 seconds. The unit will
beep, the light in the DRAIN touch pad will
illuminate and the drain valve will open for
a period of 2 minutes. This should be
enough time to drain a full capacity of
water. This operation may be repeated as
many times as needed to completely drain
the steamer basin.
2)
Touch DRAIN again while in the drain mode
operation to shut the drain valve. The light
in the DRAIN touch pad will go out.
If you do not have a fixed drain connec-
tion, use caution when draining hot water
from the steamer basin to avoid burns.
Use a heat-resistant receptacle with a
minimum 2
1
/
2
-gallon (7.6 L) capacity. The
doors of the base cabinet must be locked.
Touch control panel
DRAIN
touch pad
CLEAR
touch pad
”+” and ”–”
symbols
