STX International STX-4000-TB2, Инструкция по эксплуатации

Страница: 8 / 20

- 4 -
GRINDING HEAD ASSEMBLY
1. Loosen the head locking/side knob enough to insert the grinding
head onto the main unit (see Parts & Placement on page 3).
Tighten the head locking/side knob to stabilize the grinding head.
2. Insert the auger into the front of the grinding head with the short
tip of the auger facing out (Figure 1). When you insert the auger,
you may have to twist it just a little until you feel it set into the
motor housing.
3. Mount the cutting blade on the front of the auger (Figure 2).
Note: The flat, sharpened end of the cutting blade MUST be
facing OUT, otherwise IT WILL NOT GRIND PROPERLY, WILL
ruin the grinding head and possibly the main unit! (See Correct/
Incorrect Cutting Blade Assembly photos on pg 5).
4. Mount the grinding plate in front of the cutting blade and make
sure the notch on the side of the grinding plate fits into the slot on
the side of the grinding head (Figure 3). The grinding plate will not
sit flush with the front of the grinding head – it will stick out about
1/16”. This is the correct position of the grinding plate.
5. Screw the front grinding head screw cap onto the front of the
grinding head – DO NOT OVER-TIGHTEN (Figure 4).
Figure 1 Figure 2
Figure 3
Figure 4
Grinding Head Assembly