17
a
988
mm
c
b
2
1
4
3
Stûv 30-up - installation [en] - 0209
SN 68 719 > ...
Positioning of the stove
Fitting the console
Draw a horizontal line 98.8 cm from
the ground (to align the upper part of
the console) [photo 1] and attach the
console using one of the two central
holes.
Position the console level and at the
right height and get the fittings ready.
Please note that if you want to insert
the insulating kit (where the wall is
made up of combustible materials),
the heads of the screws or other
means of attachment cannot extend
beyond 1 cm.
The installation engineer will make
sure that the strength of the wall and
the attachments is sufficient:
- to bear the weight of the stove and
its accessories,
- to resist shock caused by the rotation
of the drum.
Ensure verticality between the console
and the wall [photo 2] by using the
wedges [a] supplied with the stove if
necessary. Please note: The console
and the connection chamber supports
must be on the same vertical plane.
Ensure the console is vertical and
attach at as many points as necessary.
If the stove is fixed to a wall
made up of combustible
materials…
… you will have ordered an insulating
kit with your stove.
The metal side must face the source of
the heat.
The 430 x 186 mm insulating panel
is placed between the connection
chamber supports [photo 3].
Straighten the lip piece [b] to hold the
panel. The 536 x 160 mm insulating
panel goes into the console [photo 4].
Slide the upper part behind the metal
plate of the console; position the
bottom onto the lip piece [c]. Bend
the lip piece to immobilise the panel.
The insulation of the flue is carried out
at a later stage.
