6.
Connect the two buckles at the front. (The buckles in the front will connect leaving one female end
open in the front and one male end buckle unattached closest to your body.) (See Figure 2)
Figure 2
7.
At this time, make any adjustments if the carrier is riding too high or too low and tighten straps as
necessary. It is recommended that you adjust straps higher than you would initially prefer, as a
shift of weight will lower the carrier a bit and you may need to make slight adjustments after both
babies have been placed into the carrier.
8.
After your carrier has been adjusted the first time, to remove it you may simply unbuckle the front
buckle as you would a jacket or backpack, and leave it assembled for the next use.
Loading the Carrier-Twin Inward Position
1.
After putting on the carrier using the instructions above, sit on a soft flat surface (such as a bed-or
a couch with secured car seats near you), and safely place your babies next to you (where they are
not in danger of rolling off).
2.
Open the inside child buckle on the side of the carrier you are going to be loading.
3.
Pick up your baby, and place him/her into the carrier. With one hand on the baby, use the other
hand to reach into the leg holes to help guide the baby’s feet.
4.
Once both legs are through the carrier, make sure the snap on the bottom is adjusted so that each
leg is snug. Close the buckle.
5.
Make any necessary adjustments to be sure that the baby is seated all the way down into the carrier
before repeating the process on the opposite side.
6.
Open the interior buckle of the second side of the carrier.
7.
Pick up your baby, and place him/her into the carrier. With one arm holding the baby, use the other
hand to help guide the baby’s feet into the leg holes.
8.
Once both legs are through the carrier, re-adjust the buckle.
9.
At this time, make any adjustments if the carrier is riding too high or too low and tighten straps as
necessary. It is recommended that you adjust straps higher than you would initially prefer, as a
shift of weight will lower the carrier a bit and you may need to make slight adjustments after both
babies have been placed into the carrier.
10. After your carrier has been adjusted the first time, to remove it you may simply unbuckle the front
buckle as you would a jacket or backpack, and leave it assembled for the next use.
