9. Removal and installation of E-bidet
8. Nozzle cleansing
7.cleansing filter screen
Pull power plug off and turn
off the water supply
Close
Plug in
Close
Close
unscrew the plug and
remove the filter screen.
Clean the filter screen
Install filter and
tighten plug
Turn on the water
Soap
15
E-bidet removal
（1）Pull power plug
off and turn off the
water supply.
(2) Open the cover & seat. Pull out the
rubber pads on both sides of the electronic
cover, use the Phillips screwdriver to
remove two screws, and remove the gasket.
(3) Pull the complete E-bidet up, remove the
clamp hose and disassemble the two braided
hoses by wrench. Then remove the E-bidet and
place it on the floor correct side up.
