Studio Electronics SE-3X, Руководство пользователя

Страница: 22 / 46

8
EDIT PAGES
!
W hat’s in the Menus?
11 edit windows to navigate functions not accessible or fully accessible on the front panel worthy of your time and
attention. Maneuver via the < >, up/down arrows, or press and hold SHIFT & rotate encoder.
GLIDE / NOTE PRIORITY PAGE
GLIDE :
Selects Linear or Exponential glide and glide o ff .
AUTO GLIDE :
Pitch bends from chosen interval to note
being played. Interval is selected in semitone increments
up or down one octave. Glide pot on panel sets the bend
rate. Normal glide is defeated when any auto bend
interval is chosen.
MULT TRIGGER :
When on, fi lter
envelope is triggered with each keystroke; when o ff , the
envelope is triggered only when key is fully released then re-struck.
NOTE PRIORITY :
Selects LOW, HIGH,
PARA(phonic), LAST. Determines how 2 - 3 overlapping notes will be handled: LOW ignores higher notes, HIGH lower
notes, PARA allows the the Oscillators to be played by 3 di
ff erent MIDI notes.
OSCILLATOR TUNE PAGE
TUNING MAIN :
Continuously varies overall pitch fl at or
sharp just over a semi-tone.
OSC1, 2, 3 :
Adjusts
individual pitch in half steps: 0-63.
FINE 2, 3 :
Continuously varies Oscillator 2 & 3’s pitch fl at or sharp
just over a semitone.
AUDIO MIXER PAGE
OSC1, 2, 3 :
Adjusts individual output levels: patches
with multiple waveforms or multiple oscillators may
produce (primarily pleasant) distortion from overloading
the
fi lter input. Decrease mix levels to avoid “browning
out.”
RMOD :
Adjusts Ring Modulator level—the mix, or
heterodyne of OSC2 and OSC3—and outputs the sum
and di
ff erence of the frequencies present in each
waveform, making it a heroic harmonic thickener and
warmer.
N2VCA OFF :
If OFF, Noise passes through Filters to VCA, if ON, noise is routed around fi lters directly into the
VCA. A good B3 keyclick simulator: assign Noise to either ENV3, or ENV4 for short decay contouring.
ENVELOPE EDIT PAGE
Displays envelopes 1 - 4 destination and velocity
sensitivity settings.
ENV1 VCF
&
ENV2 VCA
, are fi xed to
fi lter and ampli fi er respectively, 3 & 4 are assignable.
Envelope 3 & 4 destinations:
PW1, 2, 3 :
OSC1, 2, 3 Pulse
Width;
MIX2 :
Level of OSC2;
SWP2 :
Filter decay “sweep"
22