Studio Electronics SE-3X, Руководство пользователя

Страница: 7 / 46

2
UNPACKING & INSPECTION
!
Check the contents of the shipping carton. Be careful when unpacking your Midimini to insure nothing is missing or
damaged. Save the carton and packing materials for possible factory calibration or repair issues in the future.
SE-3X ships with the following items :
1. IEC power cord
2. User Manual
3. SE Sticker
3
SETUP, CONNECTIONS & CARE
!
WHAT YOU WILL NEED
1. A clean and sturdy surface where you can set your SE-3X .
2. A properly grounded AC outlet supplying 115 Volts to 240 Volts AC; 50/60 Hz .
3. One 1/4 Inch (TS) Male Instrument Cable, and means of ampli fi cation or monitoring: there is no headphone
connection.
POWER
Plug the included IEC cable’s female end into the IEC power jack on the back of your SE-3X , and then plug the male
end of the cable into an AC outlet. The SE-3X’s auto-switching regulated supply will operate properly on either 115
volt or 240 volt AC line voltage.
NOTE :
Allow SE-3X 5-10 minutes to warm up before use, as it is an Analog Instrument. If the unit has been
subjected to temperatures under 60 degrees for an extended period, optimal oscillator tuning and stability may
require 15-20 minutes of warm-up time, during which time you could dig deeper into this manual. Avoid operation
in direct sunlight.
AUDIO OUTPUT
With the CONTROL VOLUME knob turned to 0, plug one end of a 1/4” instrument cable into the Audio output and
the other end of the cable into your mixer, ampli fi er, or audio interface. Adjust
VOLUME
to desired level.
NOTE :
The AUDIO out jack is TS and TRS 1/4” cable compatible.
CARING AND CLEANING
Clean the ‘3X with a soft, nearly dry cloth only; do not use solvents or abrasive detergents. The semi-matte fi nish is
unique and requires thoughtful handling and maintenance—like anything of beauty; it’s a luxury fi nish to be sure
.
7