Studer D424, Инструкция по эксплуатации и обслуживанию

Страница: 67 / 189

D424 MO Recorder
E4/14 Operation
SW V 1.6 Date printed: 06.03.02
• You can see the available space for recording with a [REC+STOP] com-
mand. The top bar is an indication of the total recorded space, and the third
line shows the time available for recording.
• Please note that the free recording time depends on the selected format:
There is more recording time available with 16 bit resolution or with
44.1
kHz sampling rate, than with 24 bit resolution and/or 48 kHz sam-
pling rate.
• Check the input level. The sensitivity of the analog input can be aligned to
match your standard studio levels.
4.4.7 Assemble Recording
Recording is simply started with [REC+PLAY] and stopped again with
[STOP] .
During the recording process, the available recording space is displayed. If
no disk space is available anymore, the D424 automatically stops.
The new take number appears in the position line (i.e. the 2nd display
line).
Every new recording session is pasted to the end of the current session,
regardless of the position before starting. A new take number is automati-
cally assigned.
4.4.8 Insert Recording
Insert recording allows to overdub existing recordings. It corresponds to
the destructive recording mode of a tape recorder.
• Place the D424 to the beginning of the section to be replaced, and start
with
[REC+PLAY] ,
or
• listen to the previously recorded material and punch-in on-the-fly with a
[REC+PLAY] command.
• For a record punch-out, press either [PLAY] or [STOP] .
After performing an insert record, index markers are placed at the punch-in
and punch-out positions, and the two points are automatically transferred
to the IN and OUT edit registers for later editing.