14 Operating Instructions: DTP08(-Ex)
Consumables
All unit consumables are available from STS. The unit must be fitted with original STS
consumables unless otherwise stated. Any deviation from non-original consumables may
result in injury to personnel or damage to the unit and will invalidate the warranty.
Polycarbonate Guarding Replacement
The polycarbonate guarding should be replaced if damaged, cracked or visibility is
reduced. These are available from STS.
To replace the polycarbonate guard, isolate the unit in a safe area, then proceed as follows:
•
Remove the old guard.
•
On the new polycarbonate guard, peel back the protective film along all long
edges.
•
Slide the new polycarbonate guard into one side of the guarding frame. The
recommended method to bend the polycarbonate guard into position is to have a
second person assist. The first person must push the guarding edge into the guarding
frame whilst the second person pushes the polycarbonate guard from the opposite
side. The second person should apply pressure centrally to help form the required
curve. Once a small section of polycarbonate guard edge is positioned into the
guarding frame, press in the remaining edge whilst taking care to ensure fingers do
not become trapped.
Polycarbonate
Guard
Guarding
Frame
Pressure
