Maintenance Manual
10
2.2 LUBRICATION REQUIREMENTS
The only components of the bed needing periodic lubrication are the four actuator screws. They
should be checked every year and lubricated every two years.
The bed uses oil-impregnated shoulder spacers at hinge points.
Do not
lubricate these shoulder
spacers. When shoulder spacers are found worn, replace them.
ACTUATOR SCREW LUBRICATION
Required Tools:
Phillips Screwdriver
1/4" Ratchet (w/6" extension) and 5/16" socket
OG2 Grease
Brush
Procedure:
Head and Thigh Actuators
1. Raise the bed fully up and apply the brakes.
2. Remove the plastic molded shells from the head and foot sections.
3. Fully raise the head section and flatten the thigh section. Lower the four siderails.
4. Unplug the bed power cord from the wall outlet.
5. Lift and fold back the foot section toward the head end of the bed.
6. Using a Phillips screwdriver, remove the four screws (A) holding the cover plate to the frame
and remove the plate. Remove the optional night light if present.
7. Using a 1/4" ratchet (w/6" extension) and a 5/16" socket, remove the two screws (B) holding
the dust tube of each actuator. Push the tube back to uncover the screw threads.
C
C
A
A
U
U
T
T
I
I
O
O
N
N
B
B
Figure 2.2
A
Содержание FL25E
