Struers Discotom-60, Инструкция по эксплуатации

Страница: 53 / 258

Discotom-60 /-65
Instruction Manual
49
Message/Error Type Explanation Action
Feed speed reduced:
From x.xx mm/s to y.yy
mm/s MESSAGE
(#14) An automatic feed
reduction occurred during
cutting. For information only.
Do you want to continue
with the reduced feed
speed? MESSAGE
(#15) During cutting, feed
speed was automatically
reduced. Press “Yes” to use the adjusted (reduced)
feed speed for the next cutting operation.
Press “No”, to use the original feed speed.
Cutting motor brake
error! ERROR
(#16) The braking operation to
reduce the cut-off wheel’s
rotation took too long. The braking circuit has developed a fault.
Contact a Struers service technician.
LIN-bus error during
power on, please call
service technician ERROR
(#17) During power up, 1 or
more LIN-bus modules
were defective.
The LIN-bus modules are
small control units
connected to a single
cable. They perform
control functions, such as
switching the cutting
chamber light on and off,
and moving the Y-table.
Switch off and on at Main Switch.
If the error message is still displayed,
contact a Struers service technician.
In certain circumstances (dependent on
which module has failed) it may still be
possible to operate the Discotom in
“Manual” cutting mode.
Cutting table blocked! MESSAGE
(#18) Operator used the Y-table
joystick and the table did
not move. Check that the Y-table’s runners are not
obstructed. If they are, clear them and try to
operate the table again. If they are not, or
clearing them does not help, contact a
Struers service technician.
Protection hood not
closed! MESSAGE
(#19) The start button

was
pressed whilst the cutting
chamber hood was open.
Close the hood and press the start button

again to start cutting.