E;;iTRDNfiWAV
4400-Lb. Capacity E
xrtra-Long Pallet Jack
OWNER'S MANUAL
• Wear steel-toed boots while operating the pallet jack.
• Check for damaged parts before operating. Do not operate a damaged or faulty pallet jack.
Do not attempt repairs unless you are trained or authorized to do so.
• Operate a pallet jack from a designated operating position. Keep hands, feet, and other body
parts clear from the lifting mechanism and under the forks of the pallet jack.
• Do not use the pallet jack to transport people oranimals.
• Be sure the load is stable and secure before moving.
• Be sure to evenly distribute the load before moving.
• Be sure the length of the forks match the length of the pallet.
• Lower the forks to the lowest height when the pallet jack is not in use.
• For use on a hard, level surface. Do not use on a grade or angled surface.
• Do not use if the operator is not physically capable of safely operating with a full load.
• When lifting a pallet jack, the hydraulics may retract the wheels into the frame of the forks,
crushing fingers, feet, and other body parts.
• Do not place your hands on the side of the pallet jack while lifting. Always use the end of the
forks for lifting.
Assembly Instructions
it.WARNING:
Attaching the Handle to the Pump Unit
• Check if are all parts included and not damaged
• Do the work according to the daily inspections as well as functional checks.
• Eventually assemble the truck according to following instructions.
Before assembling, please make sure, that the following supplied parts are included
and not damaged:
• l pc axle with hole (3)
• 2 pc dowel pin (4) [one is already assembled with the axle]
• l pc pre- assembled tiller arm (l)
• 1 pc pre- assembled chassis with pump unit (2)
Note: The marked number on the tiller arm package and the chassis should be the same.
When attaching the handle, you had better squat just in front of the pallet truck.
• Insert the tiller arm(l) into the pump piston, then use a hammer to insert the axle with hole
into the hydraulic pump and tiller arm from the right to the left.
• Set the control lever of the handle to the 'LOWER' position, then pass the adjusting nut,
adjusting bolt through the hole of the axle(2) with your hand.
• Press the tiller arm down; take away the pin{2)
• Set the control lever of the handle to 'RAISE' position, then raise the lever plate with the pin
and insert the adjusting bolt into the front slot of lever plate. Note: Keep the adjusting nut
under the lever plate.
• Use a hammer to insert the 2 dowel pin {4) into the 2 hole of the axle. The draw-bar is now
assembled to the pump.
Fig. 2
3
of 11
