Strongway 52517, Руководство пользователя

Страница: 6 / 11

Page 6 of 11

Do not use to lift people or animals.

Keep persons and property clear from under the load.

Do not leave loads suspended when the gantry crane is unattended.

Do not allow the load to swing or roll against the support members.

Inspect the crane for damaged parts and loose bolts before each use.

Do not use the crane if there are damaged parts. Replace damaged parts before continuing use.

Do not adjust height or disassemble crane while loaded.

Secure trolley and hoist in the center of the beam when adjusting height.

Do not push or pull crane with a forklift or other vehicle.

Never push the load when trying to move the crane. Always push the crane.

When moving crane while loaded, keep the load close as close to the floor as possible and
position the load in the center of the beam.

Do not anchor the legs to the floor.

Secure the trolley and hoist in the center of the beam when adjusting the height.
Assembly Instructions
Step 1
Attach the two plates (#20) from the two sides to the one end of the crossbeam (#19). Secure with the
four bolts (#1), washers (#2), spring washers (#3), and nuts (#4). Repeat for the other end.
Step 2
Attach each inner vertical post (#21) assembly to the crossbeam (#19), secure with the 8 bolts (#1),
washers (#2), spring washers (#3), and nuts (#4).
Step 3
Attach the four (4) swivel casters (#27) with the brake to the base assembly (#26). Apply grease to the
zerk within each caster.
Step 4
Attach each outer vertical post assembly (#23) to each base assembly (#26) making certain that the
slot at the two sides of the outer vertical post assembly are facing the castors
’ direction. From the top,
insert 2 bolts (#14) through the base of the outer vertical post assembly and into the base assembly
(#26). Slip the washer (#2) and spring washer (#3) on and secure by tightening on the nuts (#4).
Step 5
Attach two (2) support tubes (#22) to each outer vertical post assembly (#23). Insert the bolt (#5)
through the top of the support tube and through the eyelet. Slip on a washer (#6), spring washer (#7)
and secure with a nut (#8). Attach the other end of the support tube to the base assembly with bolts,
washers, spring washers, and nuts. Repeat for all 4 support tubes.
Step 6
Insert the inner vertical post (#21) into the outer vertical post (#23). Insert one of the pins with the
chain (#18) through the slot and the inner vertical post hole so that it goes all the way through to the