21
1. Place the anchor roller on the deck in the right place. It is important that the roller of the anchor roller
goes out beyond the edge of the boat, so that the anchor does not catch or fall on the boat’s body when
it falls or rises.
2. Draw a straight line on the deck at the intended location of the winch.
3. Carry out the marking by attaching the winch and the anchor roller to the installation site, so that the
centre of the winch spool being aligned with the centre of the anchor roller.
For convenience, special marks are made on the winch frame and on the anchor roller.
4. Mark the locations for the holes of the mounting bolts of the winch frame and the cable entries.
Diameter of the holes for the bolts is 8.5~9
mm; the hole for the cables is Ø30
mm.
5. Inspect the area below the
deck of the boat and check that there are no obstacles to the winch
installation. Drill the holes.
