20
21. Route the end of the anchor rope into the transparent polymeric tube supplied with the anchor winch
to prevent cuts and abrasion of rope on the bottom of the pond, which leads to the destruction of the
anchor rope.
22. Do not use the winch if your battery does not hold the load when
you testing it with a load fork. If the
battery voltage drops below 9 volts, the winch control unit (relay) may fail. In this case, repair and
replacement of damaged parts will be at the expense of the buyer and will not be a warranty case.
5 WINCH INSTALLATION
Unpacking
When unpacking, pay attention to any
damage that might have occurred to your anchor winch during
transportation and delivery. In case of detection of shipping
-
related defects, please contact your carrier
to reimburse you for damages related to poor delivery of the goods.
Installation
Unscrew the 4 screws and remove the winch cover. Make sure that all bolts are tightened and all electrical
connectors are connected.
The anchor winch can be installed on the bow of the
boat.
10. When installing on a thin
-
walled deck, you can buy a boat a mounting platform separately, or
strengthen the installation site with Bakelite plywood or other dense material to provide the largest area
of the reinforced section and load distribution.
Please note, the anchor winch should be installed on a flat surface, so do not violate the body geometry
when tightening the bolts of the winch frame.
Important:
When installing the winch, the center
of the anchor roller must coincide with the center
of the
spool and is on the same straight line with it. This is necessary for the correct operation of the winch
mechanism. In case of non
-
observance of this condition, the anchor rope may fall outside the spool, which
in turn can lead to spontaneous dropping of the anchor and/or failure of the winch, which is not
considered a warranty case.
