2.0 YoUR RECEIvER
2.1 DEfAULT PIn: 1234
2.2 front Panel
Fig. 1
1.
IR sensor
Point your remote control towards this sensor.
2.
4 digits display
Indicates current time in STANDBY mode. Indicates current
channel number in OPERATING mode
3.
Mode indicator
RED indicates that the receiver is in STANDBY mode.
GREEN indicates that the receiver is in OPERATING mode
4.
USb
Connector for USB storage devices.
2.3 Rear Panel
Fig. 2
1.
AnT In
To connect to your antenna for reception of broadcasted signals.
2.
AnT oUT
To connect the terrestrial antenna signal to your TV set. This
connection will allow you to watch digital terrestrial programmes
depending on the tuner of your TV and local broadcast
conditions
3.
S/PDIf Coaxial:
To connect your receiver to a digital home theatre, AV receiver or
digital audio amplifier.
4.
HDMI
To connect your receiver with your TV set using an HDMI cable.
5.
Tv SCART
To connect your receiver with your TV set using a SCART cable.
6.
Audio L/R
To connect your receiver to an analogue audio amplifier.
7.
Power Cord
Your receiver requires a supply voltage of 220~240V AC
(Auto-selectable), 50/60Hz +/-5%. Please ensure the local power
specification meets these requirements before connecting your
receiver to the wall outlet.
2.4 Remote Control
Fig. 3
1.
q
Switches the receiver On/Standby
2.
!
Mutes all audio outputs of the receiver
3.
PG+/PG-
Page up/down in all list modes
4.
DTv/vCR
No function
5.
Info
Opens the current channel information; 2x opens the current
event information and 3x the signal information
6.
voL+/voL-
Increases/decreases the volume level
7.
MEnU
Opens the main menu, in a menu you will get one step back
8.
EXIT
Exits from the menu or sub-menu
9.
pq
Menu Off: Change channel to next/previous.
Menu On: Moves the cursor up/down.
10.
tu
Menu Off: Decreases/ increases the volume level. Menu On:
Change settings for specific menus
5
