EN
1. Install the knife and scissor sharpener module.
2. Switch the sharpener on by pressing the on/off switch into the on position “I”.
3. Open the scissors completely and position so that the bevelled cutting edges is facing the sharpening
wheel.
4. Slide one blade of the scissors through the scissor sharpening slot.
5. Draw the blade across the sharpening wheel from the pivot to the tip using light steady pressure.
6. Remove the scissor and turn over to sharpen the second blade.
7. Repeat until clean, sharp edges are obtained.
DRILL BIT SHARPENER
1. Install the drill bit sharpener module.
2. Remove the clamp assembly and insert a drill bit. Tighten the clamp assembly lightly so that the drill bit
can still move.
3. Place the clamp assembly with the drill bit into the “V” guide by locating the groo
ves on the side.
4. Rotate the drill bit while pushing the “V” guide onto the drill bit until all 4 drill tips touch the “V” guide.
5. Tighten the clamp assembly to secure the drill bit in position and then remove the clamp assembly.
6. Insert the clamp assembly and drill bit into the module central locating slot.
7. Switch the sharpener on and move the upper section of the module from side to side with light pressure.
8. Remove the clamp assembly, rotate the drill bit 180° and repeat steps 3
-7 for the opposite side.
