EN
2.
Insert the plug into a suitable wall outlet after turning the thermostat knob counter-clockwise to the
minimum position and setting the power switches to “O” OFF. The heater is suitable for operation on an
A.C. power supply having the same voltage as that show on it’s rating label.
3.
Turn the power switch knob to either “I” (Low heating) or “II” (Medium heating) or both “I” and “II” is
“III” (High heating).
4.
Turn the thermostat knob clockwise to maximum position. When the temperature rises to with a
comfortable level, slowly turn thermostat counter-clockwise until the power indicator light just goes
out. To adjust the room temperature turn the thermostat clockwise to raise the temperature, or
counter-clockwise to lower it. Your unit will be automatically set an on-and-off cycle to maintain the
current room temperature according to thermostat setting. (Note: It normally requires approx. 15
minutes to reach the operating temperature.)
5.
To turn off the heater, turn the power switch knob counter-clockwise to “O” OFF. The power indicator
light turns off.
6.
Unplug the heater from the electrical outlet when it is left unattended or is not in use.
CARE AND CLEANING
CAUTION:
Allow the heater to completely cool before handling or cleaning it.
Ensure the heater is in the “O” OFF position and the Power Cord is unplugged from the electrical outlet before
cleaning the heater.
- Always ensure the heater’s housing is intact and completely assembled before each use.
- Do not touch hot surfaces. Always use the handle of the heater. Use protective mitts or gloves to avoid
serious burns or other personal injury.
- Clean the exterior surface of the heater by wiping it with a soft, damp cloth.
CAUTION:
Do not allow water or other liquids to run into the interior of the heater, as this could create a
fire and/or electrical hazard.
- Do not use any abrasive cleaners or solvents, as heater damage will occur.
- Store the heater in a clean, dry place when it is not in use.
MAINTENANCE
1.
Always disconnect the appliance and let it completely cool before any maintenance.
2.
Use a vacuum cleaner to remove dust on grilles. Clean the outside of the unit with a damp cloth and
then dry it with a dry cloth. Never immerse the unit in water, nor let water drip into the unit.
WARNING: TO AVOID OVERHEATING, DO NOT COVER
ENVIRONMENTAL PROTECTION
(Disposal of the product at the end of its life)
Waste electrical products should not be disposed of with household waste.
Please recycle where facilities exist. Check with your Local Authority or
retailer for recycling advice.