EN
is a non-resettable switch which will require the unit be returned to an Approved Service Agent for
replacement.
If overheating or malfunctions continue, return the heater to an Approved Service Agent for examination.
TO ASSEMBLE
1.
Unpack the Castor Wheels and Arc-shaped Brackets from the heater packaging.
2.
Turn the radiator upside-down on a scratch-free and stable surface to prevent damage to the paint finish
or your floor surfacing.
3.
Fit the two (2) Castor Wheels onto the radiator by placing the Arc-shaped Brackets between the
outermost fins on each side of the radiator.
4.
Securely fasten the two (2) Castor Wheels onto the radiator by screwing one (1) Wing Nut onto the
Foot.
5.
Turn the radiator in upright position after the Castor Wheel Assembly fitted. For the correct upright
position, please refer to fig. below
TO OPERATE
1.
Place the heater in an upright position on a flat, steady, stable, heat-resistant surface. Make sure there
is nothing flammable or heat sensitive within 1 meter (40 inches). Operating the heater in any other
position could cause a hazard.
Only O operateO theO heaterO ilO lormayO
uprightO positiolO withO CastorO WheeyO
AssembyiesO attachedO toO theO bottomO ofO theO
ulitO(wheeysOolOtheObottom,OcoltroysOolOtheO
top),O al O otherO positiolO couydO createO aO
hazardousOsituatiol
3.
Thermal fuse
In the event that the automatic thermal cut-off fails to operate the heater has a further safety device. This
Switches off the heater in the event of overheating or malfunction and resets once the temperature drops
to a normal level.